# TS0601 – turning off via Gladys scene doesn't reach the device

**URL:** <https://community.gladysassistant.com/t/ts0601-turning-off-via-gladys-scene-doesnt-reach-the-device/11563>\
**Category:** Configuration\
**Created:** [November 12, 2026, 5:58pm UTC](https://community.gladysassistant.com/t/ts0601-turning-off-via-gladys-scene-doesnt-reach-the-device/11563 "2026-11-12T17:58:18Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![displaced.comb474](https://gladys-assistant-community.b-cdn.net/letter_avatar_proxy/v4/letter/d/b5ac83/32.png) [@displaced.comb474](https://community.gladysassistant.com/u/displaced.comb474)\
**Post date:** [November 12, 2026, 5:58pm UTC](https://community.gladysassistant.com/t/ts0601-turning-off-via-gladys-scene-doesnt-reach-the-device/11563/1 "2026-11-12T17:58:18Z")

</div>

I’m using a Moes BRT-100 (TS0601) connected through Zigbee2MQTT.

When I turn the thermostat off via a Gladys scene (sending `{"preset": "frost_protection"}` or `{"system_mode": "off"}` through the “Zigbee2MQTT message” action), the command never reaches the device – the valve keeps heating.

However, if I set the same command directly in the Z2M UI (device → set), it works perfectly, and Gladys then correctly shows the state as “off”.

So the issue seems to be on the Gladys → Z2M side. Is there a known problem with the “Zigbee2MQTT message” scene action, or am I missing something in the configuration?