Integration - Renault / Dacia

Development
1

Hello,

Thank you for this nice integration.

I have a few remarks to make:

  • the vehicle is indicated as plugged in while the cable is not connected (I had this problem with my V2G integration and Claude fixed it:
    The Home Assistant integration has just added the states « cable plugged in » and « vehicle connected » read from other addresses of the terminal. I am consulting the source code to retrieve the exact names.

    I discovered that the integration v1.5.0 exposes the reliable pilot signal (A/B/C/D) via /status/chargingmodule and /status/custominfo, unlike the old indicator which remained stuck on « connected » and caused the false « plugged in ». I will use these new addresses to correct the state detection.

    The new signal « car plugged in » is in place.

  • What is the difference between « Charge: Plugged in » and « Charge status: vehicle connected »?
    It would be better to have the same info, I think.

  • Having other information, by day, by week, by month…

  1. the duration of each charge,
  2. the range recovered
  3. the range recovered/charge duration ratio
  4. the electrical consumption of the charge
  5. the cost per 100km
  6. …

But perhaps all this information is already in the integration with the OCPP protocol.

Perhaps I could also add them to the V2G integration?