Negative solar panel production: shelly 1PM gen4

Configuration
1

shelly 1PM gen4 connected to my zigbee network, it transmits a negative power from my beem solar panel.
I would like to have it in positive on my graphs
It might be very simple but I can’t find it
Thanks :slight_smile:

2

Hi @Olivier.L57,

To test:
The official Shelly 1PM Gen4 documentation indicates an option called Reverse power measurement (reverse power measurement).
Here’s where to find it:

  1. Open your Shelly’s IP address in your browser.
  2. On the home page, select the output (Output).
  3. Open the settings for that output (Output Settings).
  4. Look for Reverse power measurement.
3

Thanks for the tip!!

I’ll have to switch it back to Wi-Fi and then to Zigbee again for this operation. I’m already scared. It’s a bit of a pain :wink:

4

Oh, darn … does your Wi-Fi not reach his location?

5

Well, a priori, it’s either Wi-Fi or Zigbee on the module, you have to press the button five times quickly to change mode.

The notion of « quickly » varies from one country to another, from one culture to another, etc… you see the problem :sweat_smile: