Hi Pierre-gilles,
Following your request to create the topic
I have just configured the new energy management (Enedis and Zlinky_ Tic (lixee since December 8)
LINKY in STANDARD TIC mode
EDF tariff Hc/Hp. (2 off-peak time slots from 21:04 to 23:04 and from 01:04 to 07:04)
I notice inconsistencies between the consumption values on the EDF & Enedis sites and gladys
On the left-hand chart the values match Enedis’ values
On the other charts (30-minute consumption) I notice that the values for April and March do not correspond to the values recorded on the Enedis website
The annual values in euros and kWh are not correct for 2025, 2024 and 2023
Capture d’écran 2025-12-16 à 16.25.131650×1268 156 KB
I restarted the meter synchronization with gladys but it doesn’t change anything
On the Enedis graph below, before the end of April 2025 I noticed that there is only one value every two days, but the annual values are higher than my actual consumptions!!
Capture d’écran 2025-12-16 à 17.34.152188×904 164 KB
Capture d’écran 2025-12-16 à 16.30.101690×972 84.3 KB
the bar corresponding to 1:00 should be entirely in off-peak hours
the bar corresponding to 7:00 should be in peak hours and not in off-peak
the bar corresponding to 21:00 should be entirely in off-peak hours
the bar corresponding to 23:00 should be in peak hours and not in off-peak
but maybe I’m wrong
Capture d’écran 2025-12-16 à 16.27.09758×1066 39.8 KB
comparison with the EDF graph
Capture d’écran 2025-12-16 à 17.20.292188×722 23.1 KB
Capture d’écran 2025-12-16 à 16.29.131690×2422 621 KB
last point: I use PZEM-004T & esp32 via TASMOTA as energy meters
For my heat pump, my water heater (cumulus) and my sump pump (pompe de relevage)
today it is not possible to integrate them into Energy management — how can I add the 30-minute consumption variables and the 30-minute cost?