Use devices that communicate in 433 MHz via an RFx COM (for me), or an Arduino with a 433 MHz transmitter/receiver card.
Temperature probes, Weather station (possibly)
And thus have more comprehensive heating management.
Know and display the temperature and humidity outside the house.
The arduino service already exists: https://github.com/GladysAssistant/Gladys/pull/812, and there is even a docker image with this service.
After that, you just have to wait for it to be merged I think 
Hello,
Yes yes, I know it’s in development.
I’m also looking forward to this integration
@Doudy I strongly recommend using Node-RED for this kind of very DIY devices, because as far as I know there is no integration in development on the Gladys side.
Too bad
Thanks
1 Like