[Introduction] Goldorakiller

Presentations
1

Hello everyone!

Goldo, 49 years old, married, 3 kids :sweat_smile:

After spending about ten years on Jeedom, I stopped my home automation because Jeedom updates were always complicated.

I decided to get back into it and went with HA, which I only knew by name. Well, after a week, I decided to look for another solution and came across Gladys.

Gladys seemed appealing as it was described as « more accessible Â».

And so, I switched to Gladys.

My first impression is rather good. I immediately noticed the low number of integrations compared to Jeedom and HA. But since I tinker with C#, a bit of VB.NET, and some self-taught Python, I think there’s a lot to do!

Gladys is installed on my Freebox Delta in a VM.

Unfortunately, I have quite a few Enocean Evology modules (LEROY MERLIN brand, which are actually NODON).

Now I need to integrate my Enocean modules and my LEGRAND ecocompteur, which is currently blocking me a bit because I don’t master Gladys enough yet.

Any advice perhaps?

Thanks for taking the time to read me

Goldo

2

Hi @Goldorakiller and welcome to Gladys!

I don’t know if you use AI, but you can create a Gladys integration in a few minutes without writing a single line of code :wink:

Some resources:

In video:

Don’t hesitate to ask for help on the forum if needed, the community is there to help :wink:

3

Hi @pierre-gilles

Thanks for your feedback.

Yes I use Claude code. That’s also part of the reason I ended up with Gladys Assistant.

4

Welcome @Goldorakiller!

I had both and I need to start developing for the Ecocompteur because Jeedom no longer manages anything on this part, especially the clearing of the index each night due to the number of digits locked at 6 (if I’m not mistaken).
If you start this plugin before me, I’ll follow :wink: