Hello everyone, the house electrical supply is three-phase (3 x 400 V + N). For monitoring currents per phase, I installed the Lixie module via Zigbee2Mqtt. In the « Expose » tab of ZigBee2mqtt, I can see the RMS values of each phase Inst1 to 3 (see Photo). In Gladys, it is only possible to find Inst1 and Inst2. I also note that other information regarding the 3rd phase (e.g.: power) is not accessible via Gladys.
For my own information, is this behavior normal?
Have a great day and thank you in advance for your reply.
Daniel Janssens
1 Like
Hi @Janssens 
What information is missing? Normally I think you have a whitelist of information to send (in the config on the Zigbee2mqtt side), and be careful the Lixee TIC is very, very talkative.
I advise you to send Gladys only
Thank you Pierre-Gilles,
I have taken note of your remarks regarding the « verbosity » of the Lixie and the risk of Gladys slowing down. I have very little of the requested information. The goal, for the moment, is to monitor the currents of each of the phases to best balance my setup.
My question is that in Zig
Have you looked at the whitelist on the Zigbee2mqtt side?
What do you mean by whitelist ?
Here is the photo of the information available at an instant « t » from my Lixee in the Zigbee2Mqtt dashboard. As you can see, the Lixee returns the information: Iinst 1 - Iinst 2 and Iinst 3 which are the instantaneous currents of the 3 phases. In Gladys, I would like to retrieve and display these different currents; unfortunately, I only have access to the instantaneous currents of 2 phases. The same applies to the Imax and, I think, to the ADIR (these last 2 pieces of information do not interest me). It seems to be designed for single-phase and not for three-phase.
Photo of the Lixee in the ZigBee2Mqtt dashboard
For the whitelist, it’s in Specific settings in Zigbee2Mqtt (the recommendation is to include only the values you need to avoid overloading Gladys)
Everything is properly mapped in Gladys (including iinst1, iinst2, iinst3) Gladys/server/services/zigbee2mqtt/exposes/numericType.js at master · GladysAssistant/Gladys · GitHub
Are the features properly configured in your Zigbee device in Gladys?
Thank you Pierre-Gilles for your feedback.
Here is my info:
Photo of my updated whitelist (for now I’m taking all the data)
Photo of the features present in Gladys and initial
I see that the setting « Energy phase » specifies "May require restart
Thanks Pierre-Gilles for your help, no update planned. No worries, I’ll look online — if I find anything I’ll get back to you. Normally tomorrow I’ll wire the Legrand Zigbee impulse relays (télérupteurs) and I should test their implementations in Gladys. My installation is progressing.
Have a good evening
Daniel
1 Like
