Missing data from Excellux ZG-105NTH temperature probe

Configuration
1

Hello everyone,
I would need a bit of help with this temperature probe:

image
image866×820 84.9 KB

It is well declared on Zigbee2mqtt. Here is what it exposes:

image
image1001×2079 101 KB
.
In Gladys, I retrieve information, but not the « Strobe Temperature ». The only one that comes up is the temperature measured at the housing:
image
image960×301 4.11 KB

Here is what Gladys retrieves in the Zigbee2Mqtt integration:
image
image997×1389 95.3 KB

My question is: is it possible to retrieve « the probe temperature » in Gladys?
Thanks in advance

2

So you already have the Temperature and you want Probe_Temperature, is that right?

image
image402×202 8.51 KB

If that’s the case, yes, it’s easy to add. I can open a PR this week.

3

Good evening @Will_71
Yes, the temperature that is transmitted is the value measured by the box, but the temperature measured with the probe does not go back to Gladys. If you have time to make a PR, that would be great, thank you very much. I admit, I’m a bit overwhelmed with all these innovations with AI.

4

Oh don’t worry, it’s easy to add, you don’t even need AI

5

@pierre-gilles, the PR to add probe_temperature

6

Hi @Will_71
Thanks for the PR.
So for it to be active, we need to wait for a new Gladys update, right?
Have a good day

7

Yes, when @pierre-gilles has approved the PR.

8

Hi everyone!

This topic is now in development.

A PR has been opened to map the Zigbee2mqtt temperature probe (probe_temperature) to a dedicated type:

Feel free to follow the PR, test (optional, especially for small requests), and share your feedback here if needed.

9

Good evening @Will_71
Thank you so much, the temperature probe recovery is working well :ok_hand: